Keep your concrete surfaces looking their best

Schedule concrete sealing services in Lake of the Ozark and surrounding areas.

Did you have a concrete driveway, patio or walkway installed recently? Let Key Concrete help you protect the surface from weathering and daily wear. We apply high quality concrete coatings to surfaces in Lake of the Ozark and surrounding areas.


Our concrete sealing process starts with a deep clean. We’ll pressure wash your surfaces and use specialty cleaners to remove oil, grime and other contaminants. From there, we’ll apply a high-quality sealer to protect the surface from the elements. Contact us today to learn more about the process.

Ready to make your surfaces more attractive and easier to maintain? Call 573-732- 2195 now to get a free estimate on concrete sealing services.

Why should you seal your surfaces?

Applying concrete coating to your surfaces will keep them looking their best. With our help, you can protect your surfaces from:

A white check mark in a black circle on a white background.

Stains

A white check mark in a black circle on a white background.

Chemicals

A white check mark in a black circle on a white background.

Water damage

A man is painting a concrete driveway with a roller.

Here are the four levels of polishing and the degree of shine you can expect to achieve at each level:

Level 1 (flat) $2 - $5 PSF

A level 1 ground polish usually can be obtained by stopping below the100-grit resin bond. When you look directly down at the floor, it will appear somewhat hazy with little if any clarity or reflection.

Level 2 (satin) $4 - $6 PSF

A level 2 honed polish is obtained by stopping at the 400-grit resin bond, producing a low-sheen finish. When you look directly down at the finished floor and at a distance of roughly 100 feet, you can start to see a slight overhead reflection. This grit level produces a low-luster matte finish.

Level 3 (semi-polished) $5 - $10 PSF

A level 3 polish is achieved by going up to an 800-grit or higher diamond abrasive. The surface will have a much higher sheen than that of level 2 finish, and you'll start to see good light reflectivity. At a distance of 30 to 50 feet, the floor will clearly reflect side and overhead lighting.

Level 4 (highly polished) $8 - $15 PSF

This level of polish produces a high degree of shine, so that when standing directly over the surface, you can see your reflection with total clarity. Also, the floor appears to be wet when viewed from different vantage points. A level 4 polish is obtained by going up to a 3,000-grit resin-bond diamond or by burnishing the floor with a high-speed burnisher outfitted with specialty buffing pads.

Share by: